Diamond Blade Information

Diamond tools or any other power devices for which they can be dangerous if not employed properly. This article will touch base on some of the uses of general diamond saw blade do’s and don’ts. Learn more about CMP Stonemason Supplies & Tools Near Me.

You should check things before you start cutting.

(Wear correct protective gear forever) 1. Before installing on your saw, make sure the diamond blade has no damage to it (shipping or past use).

  1. Make sure that the arrow shows the correct direction of rotation when mounting on the saw, if you put a diamond blade on the back the efficiency will be greatly reduced and you won’t get the entire life out of the saw blade.
  2. To avoid the blade from slipping while cutting and to ensure maximum cutting efficiency, tighten the flanges (plates keeping the diamond blade on the crank shaft);
  3. By using a wet cutting saw, ensure sure the waters are safe and unimpeded to avoid the diamond blade from overheating and to remove any slurry break. (Cutting content left over after cutting) 5. Make sure you know the blade’s right RPM level, and use the saw as necessary.
  4. Wear respiratory protection equipment to prevent using cutting to ingest any possibly harmful soil born particles. (It’s still advised to use all the necessary protection gear even while wet cutting) 7. Make sure that the diamond blade has parts left to carve! Both diamond blades have a welding thread, so there are still around 1 mm of worthless fragments if it is laser welded or sintered. Regularly inspect your diamond blade when you find that the segments are almost worn. You can destroy your cutting saw by trimming with pointless parts.
Share

You may also like...